Z Corporation Z 406 Manuel d'utilisateur télécharger pdf (Page 45)

Z406 System User Manual Z Corporation

www.zcorp-users.com 45

6.6 OILING THE SNOWPLOWS (FOR NON-ZCAST POWDER USERS)

Two snowplows are located between the roller on the gantry. Snowplows needs to be oiled

before every build. To oil snowplows, squeeze a few drops of oil into the wicks on the

snowplow.

Wick

6.7 CLEAN UNDER THE GANTRY

Powder will adhere to the bottom surface of the gantry due to moisture accumulation. This may

cause poor surface finish and dragging of powder over the build area. To prevent dragging of

powder over the build area, it is recommended that the bottom surface of the gantry be cleaned

before every build for starch powder users and every week for plaster powder users.

1. Empty build piston of powder.

2. Put Printer offline and lower build

piston.

3. Put Printer online.

4. Unpark the carriage so that the gantry

can be manually moved.

5. Clean bottom surface with moist

paper towel and dry. Move gantry

manually if needed.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 69 70

Pas de commentaire

Z Corporation Z 406 Manuel d'utilisateur Page 45