Z Corporation Z 406 Manuel d'utilisateur télécharger pdf (Page 49)

Z406 System User Manual Z Corporation

www.zcorp-users.com 49

Front Bearing

Snowplows

Scraper Blade

Assembly

6.11 CHANGING MATERIAL SYSTEM

IF USING ZCAST POWDER

Before using ZCast powder, a hardware upgrade

(Z406 ZCast Kit, part number 06105) is needed

to prevent damage to your Printer. The three

hardware changes are new snowplows, scraper

blade assembly, and front bearing. A build plate

is also included to help remove parts from the

build envelope. Please ensure that these

hardware changes have been made before

proceeding.

For information on how to design a ZCast mold, read the ZCast Design Guide which can be

found in the Applications section of the User Group Website at www.zcorp-users.com.

To change material systems on your Z406 3D Printer, use the procedure below:

1. Remove all powder from the feed and

build envelopes. Place powder in a

sealed container to prevent

absorption of moistureinto the

powder.

2. To prevent material contamination

vacuum off any remaining powder

from the feed and build plates, and

the top deck.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 69 70

Pas de commentaire

Z Corporation Z 406 Manuel d'utilisateur Page 49